You are here

Total Recall VR Logger Patch

Total Recall VR Logger Patch

The Total Recall VR Logger Patch enables recording from digital telephone handsets where there is no-side tone or the level of the microphone is too low to trigger recording.

 

The Logger Patch is simply connected to the telephone handset curly cord and then wired to an anlog port on a Total Recall VR voice logging recorder.

Some phone handsets have different microphone and earpiece outputs to the RJ11 (4P4C) plug. Normally the center two wires on the handset jack are the earpiece circuit and the outer two wires are the microphone. If your telephone does not use standard connections, there is a splitter included in the pack to reverse the input connections to the Logger Patch.

The Logger Patch requires a 12VDC power pack to power the amplifier which will give up to 30dB gain on the microphone and 10dB gain on the earpiece. This power pack is NOT supplied with the Logger Patch.

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer